Motor Mounts

Flywheel Covers

    Spun from aircraft quality, aluminum these flywheel covers are designed to keep objects from getting tangled up in flywheel ( towels, ski ropes etc.).  They are not designed as a scatter shield nor are they intended to carry any weight other than a driveshaft cover.  The flywheel cover is 14 3/4" in diameter and 2" deep. The  center hole is 5 1/2" in diameter with a 6 1/2" bolt hole circle (5/16-18 threads)  to attach a Jet boat style driveshaft cover. V-Drive style flywheel covers have a 5 1/2" diameter center hole with a 7" bolt hole circle ( 5/16-18 threads) and use a telescoping style driveshaft cover.   Chevy flywheel covers use the stock bell housing bolt pattern to mount  in conjunction rear motor plate to carry the rear weight of the engine.  Ford flywheel covers use 2 of the stock bell housing bolts and 2 bolts that are threaded into the rear motor plate, which also carries the rear weight of the engine.

454 Chevy Front Motor Mount

Jet boat style front motor mounts are made from 3/8" thick 6061 T6 aluminum,  then highly polished. Standard mounts are 25" wide (optional widths available) and are available in 3 basic heights: V-bottom, 19 Tunnel,  and  21 Tunnel.  Mounts are made 1" deeper than need be and should be trimmed for final fit.  Rectangular fuel pump windows allow mount to fit flush against block and are only available in V-bottom and 19 Tunnel versions.  Mounts with round fuel pump holes are spaced 1" away from block for clearance and are used when stringer width or mount height intersects with rectangular fuel pump window.  Mounts are also available with no fuel pump holes.  Alternator provisions are provided for starboard side mounting.